What Conditions Need to Be Met to Install an Ultrasonic Water Meter
When installing an ultrasonic water meter, you must first consider whether the diameter of your ultrasonic water meter is consistent with the diameter of the pipe, that is, the diameter of the meter body is consistent with the diameter of the front and rear pipes, so that it can be installed and used without causing errors in flow calculation. In addition, the selected ultrasonic water meter must choose products produced by regular manufacturers, so that the product quality will be more reliable and the service life will be longer.
Before installing the ultrasonic water meter, the pipeline must be cleaned to avoid debris such as sand, hemp, etc. in the pipe. This operation is to avoid the problems of unstable measurement or data errors after installation, to eliminate these problems in time, to facilitate installation, and to avoid troubles caused by re-installation. The selection of the installation location must consider that the water meter is preferably horizontal or vertical when re-installing, so as to ensure normal use. Observing the ultrasonic water meter, you will find that there is an arrow on the meter body. The direction indicated by this arrow is the direction of the water flow. When installing, pay attention to the direction of the water flow and the direction of the arrow on the meter body to be able to use it correctly.
The installation position of the ultrasonic water meter must ensure that the length of the straight section in front of the meter body is 10 times the pipe diameter. The length of the straight section behind the table should also reach 5 times the length of the view. Such a requirement is also to be able to better measure the more accurate water flow. It is necessary to avoid the problem of moisture in the installation location, and it is best to install it in a ventilated and dry environment to prolong the life. If the water vapor is large, the accuracy may also change, which will shorten the use time. For users, they should also understand why their ultrasonic water meters are easily damaged when they are used for a short period of time, and it is necessary to consider whether there is a problem with the installation location. Some users may say that the water flowing inside the water meter is always full, so the influence of accuracy does not mean that the humid environment can affect it. It can only be said that the humid environment will cause the water meter to rust and cause the electrical appliance to fail. Special attention must be paid to this aspect.
