Features of the Heat Meter for Both Cold And Heat

Features

The flowmeter adopts advanced coil-type sensor, which will not be interfered by magnets, and will not attract rust and impurities in the water, ensuring accurate measurement for long-term use;

●Using helical diversion multi-beam mode to push the tangential flow of the impeller to be uniform. Effectively overcome a large amount of wear on one side of the single-flow impeller caused by the force in one direction. There is no need to add a straight pipe to adjust the water flow, and it can be installed horizontally and obliquely, which improves the flexibility of installation;

●The only wear part inside adopts tungsten steel needle point and ruby bearing. The tungsten steel needle tip can only be processed with a diamond drill bit, which ensures the accuracy of the product's long-term operation and measurement;

●All copper parts are produced by forging process, which eliminates the phenomenon of trachoma leakage caused by sand casting process. Each heat meter has undergone a pressure test of 2.0MPa to prevent leakage;

●Compact structure, integrated design, firm structure and good damage resistance;

Small starting flow: DN32-40 achieves a ratio of common flow to minimum flow of 50:1, and above DN50 to achieve a ratio of common flow to minimum flow of 25:1;

●Direct pulse output, easy to connect;

●Cold and hot dual use, all internal materials are imported PPO;

●Reserve the installation interface of the integrator.